|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
11-01-2011, 07:27 PM | #1 |
Not Yet Wild
Join Date: Oct 2011
Posts: 23
|
Drive G29 lift question
I recently installed a jakes 6" spindle lift on my drive with 10"x8" steel wheels with a 5"x3" offset and the rims are rubbing the spindles anone ran into this? should I space the wheels out or hit the spindles with a grinder only drags by maybe 1/8"
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-02-2011, 01:18 PM | #2 |
Vegas modded 420
Join Date: Jun 2009
Location: West MI
Posts: 15,445
|
Re: Drive G29 lift question
Do the steel wheels have a larger lip on the side? It is rare people have an issue with Jakes, or that they don't say if something requires certain size wheels/etc.
|
11-02-2011, 03:56 PM | #3 |
Not Yet Wild
Join Date: Oct 2011
Posts: 23
|
Re: Drive G29 lift question
The lip on the inside may be a little larger than aluminum wheels but I looked at a ez go with the same setup and it had a couple inches of clearance think I will call jakes
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G2 Drive clutch question | Gas Yamaha | |||
Drive belt question | Big Block Talk! | |||
Drive Belt Question | Gas EZGO | |||
Drive clutch question? | Gas EZGO | |||
Stretch Lift Kit For Drive? | Lifted Golf Carts |