|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-13-2009, 02:00 PM | #1 |
Getting Wild
Join Date: Aug 2009
Posts: 89
|
G1 Governer question
Ok I adjusted the governer put in a longer screw and adjusted it out a small amount past where the stock screw would go with out the lock nut
How far can I adjust before I start to get into possibly damaging the motor ? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-13-2009, 07:27 PM | #2 |
Gone Wild
Join Date: Nov 2007
Location: Martinsburg, WV
Posts: 651
|
Re: G1 Governer question
I have adjusted both my G1's all the way each way and I only seen a little difference in speed. I now have been running my 81 G1 with no governor at all just keep in mind not to run it wide open all the time.
Calvin |
08-14-2009, 09:47 AM | #3 |
Getting Wild
Join Date: Aug 2009
Posts: 89
|
Re: G1 Governer question
Yeah your right I adjusted it and even hose clamped it and noticed very little difference I think I will just go back to a little bit longer screw and call it good Thanks for your reply!
|
08-15-2009, 02:28 PM | #4 |
Gone Wild
Join Date: Jul 2009
Location: Sand Springs,Ok
Posts: 873
|
Re: G1 Governer question
I ran the screw in all the way and mine runs 21 mph with GPS so I called it good
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
How do I adjust the governer on the ezgo gas powered 2007 txt??? please help! | Gas EZGO | |||
Precedent backfire, throttle linkage, governer | Gas Club Car | |||
Yet another governer bypass question | Gas Yamaha | |||
governer quit! | Gas Club Car |