2pg clutch puller help

[bbrazil]

i purchased the clutch puller from buggies unlimited for my 84 with a 2pg. The puller does not fit in the hole on the clutch. the rod on the puller is 5/8" and the hole in my clutch is 1/2". even if the rod fit the threaded portion would be to large to thread in the clutch. has anyone else had this problem or maybe the clutch I have is not stock. help please

[rokcrlr]

pictures would help

[steveb05]

I have both size clutches, haven't used an actual puller on either.

[bbrazil]

what is the bolt size and thread pitch so i can make a puller?

[EZ-GoingJon]

I use a 2 1\2" piece of steel rod 5/8" in diam. and a 3"x 3/4" fine thread bolt! Works great on the 2PG and the 3PG!

Jon

http://www.buggiesgonewild.com/gas-e...-gas-cart.html

[bbrazil]

i have a different clutch. the rod size i would have to use is 1/2" in diameter. The clutch hole is smaller on my clutch as well as the threaded portion for pulling. Just wondering if anyone know the bolt size and thread pitch on this clutch. or where to get the correct size puller.

[EZ-GoingJon]

[bbrazil]

I dont know how to be more clear. don't see how a pic will help. I pulled the center bolt out of the clutch. the clutch puller tool that i purchased is a 5/8 rod that is threaded at the top for pulling the clutch. The problem is that the hole in my clutch is 1/2" and the puller is too large to fit in the hole. obviously this clutch is different than most of the 2pg's out there. Just trying to find out if anyone has had this problem as well and if there is a correct puller that i can buy.

[EZ-GoingJon]

Hope this helps

http://www.buggiesgonewild.com/site-sponsors.php

[steveb05]

It should be 14mm. It may be either 1.0 or 1.5 thread pitch (1.5 being more common). If you can't find a puller on the cart sites, move over to snowmobile stuff.