1994 ez go with 4 terminal control box

[rabbitreborn]

Is this a medalist or a Marathon cart?

[bugkiller86]

I believe its a metalist. I posted the manuf# and the serial# in the first post. It does have a metal body if that means anything.

[rabbitreborn]

Medalist would have the controller on the passenger side of the cart, Marathon the controller would be in the middle of the cart between the batteries.

If it's a medalist, this may help:

Txt solenoid activation
power starts on the white wire on the 36+ of the battery pack.
Power travels to the charger receptacle, goes through a reed switch inside the receptacle and comes out on the red 12 gauge red wire. ( check for power here, 1st!)
the red wire travels back through the loom to the forward and reverse switch where it attaches to a micro.
The other side of that micro has a blue wire attached that runs under the cart to the front and arrives at the keyswitch.
The keyswitch then transfers power to a green wire which returns to the area of the forward and reverse switch.
The power then goes through a 4 pin molex connector and travels to the "pedal box" (located under the floorboard of the car) where it goes through a micro and comes out on another red wire.
That red wire comes back up to the controller/f&r area where it once again goes through the 4 pin molex connector and continues on to the small post of the solenoid.

[bugkiller86]

Thanks that means mine is a medalist. Ill check all of that should help me alot. Thanks

[bugkiller86]

Ok so I did get the cart to move! It was my micro switch in the floor had gone bad. But soon as it moved something made a sparking noise and it stopped again. But the solenoid still clicks and no burnt wires. So im getting closer1 Thanks for all the help.