|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-30-2022, 09:32 AM | #1 |
Gone Wild
Join Date: Oct 2019
Location: Houston, TX
Posts: 319
|
D&D 502 with Alltrax XCT500
All,
I have a new D&D motor coming today it is the 170-502-0001. I contacted alltrax and sent them my cart specs and got the recommended field map for my application where I like to be around 25mph. Alltrax has said I will not be happy with the D&D motor. Is that the case? Should I not install this motor and contact D&D? I was used to 25 to 30mph easy before my other motor died. I want to make sure I at least get up to 27mph at the maximum for the flat streets I live on. I am now worried that the motor will be an issue. D&D are the ones who recommended this motor to me. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-30-2022, 03:07 PM | #2 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,553
|
Re: D&D 502 with Alltrax XCT500
I can't tell you how fast you will go but both of my G29's have D&D motors and I am happy with them. My cart with standard gearing won't go over 25 without overspeeding the motor. My cart with high speed gears has a high torque version of the D&D. I have it set to go about 24 max. You can fool with different field maps to get a little more speed but unless you have oversized tires you won't get 25 with standard gearing.
|
06-30-2022, 06:18 PM | #3 |
Gone Wild
Join Date: Oct 2019
Location: Houston, TX
Posts: 319
|
Re: D&D 502 with Alltrax XCT500
I have 23" tires.
From alltrax, after I gave them the specs including my lithium setup: If you have a club car that motor should get you into the low 20’s, if you have a Yamaha or EZGO you’re not going to be a fan of the 502 motor. I attached the best map we have for the 502 motor. If you haven’t already I would change your regen battery amps down 30A and set your undervoltage for 43v since you’re running lithiums. 230AH pack should have a high enough peak discharge you don’t have to limit any current settings in the controller. Recommended map FieldCurve_RHMOT-A2-V7" |
06-30-2022, 06:30 PM | #4 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,553
|
Re: D&D 502 with Alltrax XCT500
You must have a lift if you can fit 23 inch tires on a G29. I assume you have a G29. I have the largest tires that would fit on my unlifted cart and I can get 25mph with stock gears (12.5:1) I am running Nissan Leaf cells with max voltage of 58V. I think my tires are about 21.5 inches. I have ES-66C-33 D&D motor on that cart. On my second cart with 9:1 gears, I have ES-24-14 High Torque motor. That cart also has a Leaf pack - been running that cart for over 6 years with that setup. Top speed is similar but I think that cart could be set up to run faster. I don't really want over about 20mph on a cart with only rear brakes.
|
06-30-2022, 07:02 PM | #5 |
Gone Wild
Join Date: Oct 2019
Location: Houston, TX
Posts: 319
|
Re: D&D 502 with Alltrax XCT500
I have a g22e with 6 inch lift. I had an fsip speed motor. My lithium pack is 58.4V at 100% maximum. usually 58V as well.
Last edited by Croqezgo; 06-30-2022 at 07:31 PM.. Reason: added more |
06-30-2022, 08:12 PM | #6 |
Gone Wild
Join Date: Oct 2019
Location: Houston, TX
Posts: 319
|
Re: D&D 502 with Alltrax XCT500
I may install the d&d and test it.
|
07-01-2022, 07:54 AM | #7 |
Gone Wild
Join Date: Oct 2019
Location: Houston, TX
Posts: 319
|
Re: D&D 502 with Alltrax XCT500
Any other thoughts Volt? Should I try it or just send it back? I believe the D&D motor is not a long stack motor like the admiral D4 or the FSIP speed motor.
|
07-01-2022, 08:14 AM | #8 |
Gone Wild
Join Date: May 2012
Location: Rio Verde, Az
Posts: 7,553
|
Re: D&D 502 with Alltrax XCT500
No other thoughts. I have related my experience with two G29's.
|
07-01-2022, 10:48 AM | #9 |
Gone Wild
Join Date: Oct 2019
Location: Houston, TX
Posts: 319
|
Re: D&D 502 with Alltrax XCT500
According to D&D, who have terrible customer service... The motor is rated at 3250 rpm, which would only be 18.5 MPH with a 12:1 stock gear ratio and 23" tires. I can't see how 3250 is the max RPM. I don't want to install and then get screwed on a return.
|
07-01-2022, 12:11 PM | #10 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,334
|
Re: D&D 502 with Alltrax XCT500
Plowmans has a D&D engineered motor that comes in his Riot Kit. I've got this motor and a 300a Alltrax in a G22 with 22" tires. Cruise at 25mph...
https://plowmanscarts.com/carts.cgi?...1644437116&v=2 |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Alltrax XCT500 and DPI 48V BTL Charger | Golf Carts and Parts | |||
Alltrax XCT500 Issues | Electric Club Car | |||
Alltrax xct500 Questions | Electric EZGO | |||
ALLTRAX XCT500 and D&D 170-502-0001 | Electric EZGO | |||
MOT-B2-V3 Field Map for Alltrax XCT500 | Electric EZGO |