2022 ICON Controller Parameters.

[KRAZYMATT]

Figured I would start a thread where everyone can post their findings when playing with the parameters of the new 2022 icon controllers. Post what you changed and the result. Also be a good place to post explanation in layman’s terms what exactly each parameter does as they are figured out.

[jerrygallow92]

Good call. I’ve got the parts on the way to make my cable. My main priority is to improve drivability, right now I feel like the regenerative braking is set too high, and the throttle response is too aggressive. The only time I want to be thrown back in my seat is if I floor it.

I’ll share my results.


Sent from my iPhone using Tapatalk

[KRAZYMATT]

8.3.1 is the parameter for the regenative braking. It’s
Most likely set to “1” if you change it to a “2” it turns it off.

[AdamP]

Originally Posted by jerrygallow92

Good call. I’ve got the parts on the way to make my cable. My main priority is to improve drivability, right now I feel like the regenerative braking is set too high, and the throttle response is too aggressive. The only time I want to be thrown back in my seat is if I floor it.

I’ll share my results.


Sent from my iPhone using Tapatalk

Make sure you do,the firmware update before anything else is done

[jerrygallow92]

Originally Posted by AdamP

Make sure you do,the firmware update before anything else is done

Do you know if this is something I can do myself, or does my dealer have to do it?

Originally Posted by KRAZYMATT

8.3.1 is the parameter for the regenative braking. It’s
Most likely set to “1” if you change it to a “2” it turns it off.

Thanks for the heads up!

[KRAZYMATT]

Originally Posted by jerrygallow92

Do you know if this is something I can do myself, or does my dealer have to do it?

Thanks for the heads up!

Dealer needs to perform the firmware update.

[KRAZYMATT]

As far as increasing the speed I am told it’s done different than the old Toyota/NEOS controllers. On the neos controllers you just raise the max motor rpm’s. I’m told on these new 2022 icon controllers you need to adjust the k/mh. Don’t know the exact parameter yet.

[BobInDaytona]

Originally Posted by KRAZYMATT

As far as increasing the speed I am told it’s done different than the old Toyota/NEOS controllers. On the neos controllers you just raise the max motor rpm’s. I’m told on these new 2022 icon controllers you need to adjust the k/mh. Don’t know the exact parameter yet.

You can set the rpm’s here as well if you login as admin.
When admin, rpm’s show up on the speed menu.

[rsmith4203]

Can anyone direct me on steps to make changes in the new ICON software?
There is not a blank Colum to input changes like the older NEOS software?

I have a communication green light and it is reading info on new 22 cart. how do I input the changes and send to controller?

All I want to do is increase the speed from 22mph to 29-30ish.

any help would be appreciated.

[rsmith4203]

Will do.

I guess my question is how to make the changes to controller to even see if you get gains. I try to upload changes, then download, ect...

uplug from comp.

turn off key.

wait.

turn on key

plug back in

and settings reset to original RPM (37.9)

....

so I am assuming I am not doing in correct steps and data is never reaching the controller?