1995 ezgo electric wiring

[1995 ezgo rider]

tested what you said and I have voltage on 5,6,9,10. Solenoid is not clicking at all when I do anything. What should I check next.

[1995 ezgo rider]

here is the run down on how it tested.

B +38.6 volts
# 10 pin 38.6
#9 pin .5
#5 pin 0
#7 pin 72.7 and the tester went to mV
#2 pin 1.3
#1 pin .6

let me know next what now, Thanks !!!!!

[JohnnieB]

Originally Posted by 1995 ezgo rider

here is the run down on how it tested.

B +38.6 volts
# 10 pin 38.6
#9 pin .5
#5 pin 0
#7 pin 72.7 and the tester went to mV
#2 pin 1.3
#1 pin .6

let me know next what now, Thanks !!!!!

Check the voltage on the smaller of the three wires coming out of the backside of the charge receptacle.

If it isn't 38.6V (or whatever the pack voltage is at the time), bypass the reed switch.

[1995 ezgo rider]

right where the arrow is at in the pic I disconnected them. touching the red wire I have 18 volts. so I should make a piggy back wire to that screw inside the charger connection? And just let the white wire hang disconnected?

[1995 ezgo rider]

I found this pic in the forum, so this is what I need it to do when I am done?

[JohnnieB]

Originally Posted by 1995 ezgo rider

I found this pic in the forum, so this is what I need it to do when I am done?

Yes and No.

Yes, connect the red wire as shown in picture.

No, do not put an insulating sleeve on both radsoks. The one with the black wire attached has to be left bare, that is where the auxiliary contact in the charger's plug touches to pick up battery pack voltage to turn on charger.

[1995 ezgo rider]

ok Johnnie, the cart runs!!!! Now the only problem is the beeper is on. When I push the gas it goes off. When I put it in neutral it comes back on until I put it in forward and push the gas pedal. Even when I shut it off the beeper still stays on. I hope this is the last of it! Thank you so much for helping me!!!!

[1995 ezgo rider]

do I need to buy the 50 amp fuse that goes to the cable attached to the positive battery terminal?

[marypat803]

Can someone share the battery wiring for a similar EZ-GO electric 36V cart? I just got 6 new batteries and didn't take a photo of the array before I removed the old ones. Need to be sure I don't fry anything when I hook them back up. Thanks.