|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
01-13-2018, 07:20 PM | #11 |
Not Yet Wild
Join Date: Aug 2017
Posts: 7
|
Re: EZ Go Crawls + Brake light ON
Tried to remove and reinstall no luck still in limp mode. Also, cart not pushable in nuetral with run switch pushed to tow/maintenence .... Bearing encoder anyone think?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-13-2018, 08:23 PM | #12 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: EZ Go Crawls + Brake light ON
Encoder would not cause brake to not release when in Tow & Neutral. Or at least never has in my experience, and I been at it for a while at the Ezgo dealer.
|
01-14-2018, 09:47 AM | #13 |
Gone Insane
Join Date: Oct 2015
Location: TN/NC/GA Tri-state area
Posts: 3,952
|
Re: EZ Go Crawls + Brake light ON
The failure of the original motor brake could have taken out the motor brake fuse. Remove the plastic cover that has the Run/Tow switch, turn it over, and look for one or two caps on plugs with 2 wires. It will not be the #1/#2/#3/#4 set, it will be the others. typically 2 red wires on one and 2 yellow wires on the other. There are fuses under those caps, a 10 amp fuse and a 7.5 Amp fuse, if they are original. The 10 Amp fuse is for the keyswitch, and the 7.5 Amp fuse is for the motor brake. You can use a 10 Amp fuse for the motor brake if you cannot find a 7.5 Amp fuse. If it only has one fuse, it is an earlier model wiring harness and the keyswitch fuse is used for the motor brake as well. Good luck.
Bob |
01-15-2018, 11:14 AM | #14 |
Not Yet Wild
Join Date: Aug 2017
Posts: 7
|
Re: EZ Go Crawls + Brake light ON
No luck with motorbrake... It has the old type harness and the 1 10 amp fuse is good.
After installing new motorbrake, it is making a sound I don't remember before sounds like the rear end is clicking...? - Still limping.. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Deluxe light kit question: Not getting 12v Constant to brake switch / brake wire | Electric Club Car | |||
Tail Light / Brake Light | Electric Club Car | |||
2012 Club Car brake light switch under brake pedal pad | Electric Club Car | |||
rxv crawls at full throttle | Electric EZGO | |||
Ultimate light Kit Upgrade Brake light issue | Electric Club Car |