|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
12-01-2016, 09:59 AM | #1 |
Not Yet Wild
Join Date: Nov 2016
Posts: 5
|
2000 EZ Go lurching then stopped
Hi I have a 2000 36V Shuttle 2+2. Over the past couple of months it began to hesitate just a second when you pressed the peddle then would lurch forward and run fine. Last week it just all of a sudden died, nothing. Here is what I know:
Pack Voltage 37.6 Voltage at the solenoid and across the solenoid, with resistor removed, when peddle is pressed. Solenoid clicks when peddle is pressed. Voltage to the controller, but not out of the controller (M-b+) when the peddle is pressed. any suggestions? Hal |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
12-01-2016, 11:36 AM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,410
|
Re: 2000 EZ Go lurching then stopped
Hi Hal, Welcome to BGW.
It might be trouble in the pedal box... Which drive system are you asking about? |
12-02-2016, 07:44 AM | #3 |
Not Yet Wild
Join Date: Nov 2016
Posts: 5
|
Re: 2000 EZ Go lurching then stopped
Thanks for the reply Scotty.
Mine appears to be a PDS Series. My controller is the one on the bottom of the schematic. |
12-04-2016, 07:09 PM | #4 |
Not Yet Wild
Join Date: Nov 2016
Posts: 5
|
Re: 2000 EZ Go lurching then stopped
Anyone have any suggestions?
Hal |
12-04-2016, 07:21 PM | #5 |
Getting Wild
Join Date: Aug 2016
Location: Seneca South Carolina
Posts: 138
|
Re: 2000 EZ Go lurching then stopped
Does it still have the reverse buzzer? If so look up on here how to put it into diagnostic mode and listen to the beeps . If not I would check the F&R switch for continuity and power. I had a similar issue on time on a PDS cart and it turned out to be the F&R switch. If all of that test correctly than I would say the controller is gone.
|
12-06-2016, 09:24 PM | #6 |
Not Yet Wild
Join Date: Nov 2016
Posts: 5
|
Re: 2000 EZ Go lurching then stopped
do you know of a troubleshooting guide for the F&R switch?
|
12-06-2016, 09:25 PM | #7 |
Not Yet Wild
Join Date: Nov 2016
Posts: 5
|
Re: 2000 EZ Go lurching then stopped
and no the reverse horn is not functional
|
12-06-2016, 09:34 PM | #8 |
Getting Wild
Join Date: Aug 2016
Location: Seneca South Carolina
Posts: 138
|
Re: 2000 EZ Go lurching then stopped
The way I check them is to see if the hot wire has Pack voltage, check the switch for continuity, if all that checks out check continuity on all three of the wires from the F&R back to the 10 prone molex pulg at the controller.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G16 motor lurching when slowing down | Electric Yamaha | |||
txt low speed lurching | Gas EZGO | |||
Running real slow and lurching | Electric Club Car | |||
2000 just stopped dead | Electric Club Car | |||
88 par car lurching.3 questions | Gas Columbia ParCar |