2013 EZ-GO lights...

[ArgMatey]

Recently purchased a refurbished 2013 EZ-GO RXV from a reputable dealer. We upgraded to LED lighting but did not go with turn signals (figuring I could do that installation myself). 4-12's. 48 volt. Have been reading the forum and still a bit confused...

I've taken several pictures of the front and rear connections. They did hardwire the front turn signals to the headlights so always on with headlights. Bypassing, from what it looks like the plug in ends from the wiring harness. Took the cup holder off and a myriad of wires going everywhere. I will attach what .jpg's I can.

UP under the cup holder area are wires labeled Driver and another bundle labeled Passenger. There is a third two-wire plug (green and black) that runs out to the front but is not connected to anything else. Any ideas? Maybe for a accessory plug?

Boils down to can I adapt a universal Turn Signal Kit or should I be looking for something a little more EZ-GO centric. Pretty handy with wiring, once I get a clear understanding of what should go where...

Many thanks in advance..

[FF Titus]

Get a volt meter on that green and black. Voltage 12V?

[ArgMatey]

When we get back home next week I definitely will...
Shoulda thunk of that when I had everything apart, eh!?

[ArgMatey]

Green/Black is 12v... guess I can use that as a jump off point for dash accessory and/or other 12v addons...

[cgtech]

You have the factory EZGO lights. You can get the ezgo turn signal kit add on. It will be a super simple plug & play affair (after you remove the jumpers on the front running lights). The pic with the little 3-wire jumper is where the signal head plugs in. The Grey jumper is the brake light power to the 2 brake light wires.