|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
05-29-2016, 03:44 PM | #1 |
Gone Wild
Join Date: Feb 2009
Location: Ontario
Posts: 280
|
Yamaha Stop Switch Repair
After seeing numerous posts about Yamaha's not starting, I figured that I would document an easy repair to a VERY common problem. The Yamaha stop switches are known to fail often, and this simple fix can potentially save you $50-$80.
If you are having intermittent starting problems when you step on the gas pedal this is most likely your problem. Meaning, you have to push the gas pedal a few times in order to get a proper contact. The stop switch pictured should be the same of both gas and electric, and ranging from G11 to G29 (Drive) models. ** It is advised to have the key turned off and the cart in neutral during this repair ** Remove plastic floor mat rivets with a flat headed screw driver, and pull back the mat to expose the floor plate. Once floor plate is removed, you will see the stop switch located at the pedals. Switch is secured by two Phillips screws. Unplug the switch, and remove screws. (You will also need to open up the wiring harness retaining clip. With backing plate facing upwards, carefully remove the four small Phillips screws. Keeping in mind that there is a spring with ball bearing behind the backing plate. Once apart, clean the rocker plate with electrical contact cleaner. Paying particular attention to the contact area on the underside. Now grab the other half of the switch and turn it upside down in the palm of your hand carefully, as not to drop the ball bearing or spring and lose them. Once removed, take the spring and slightly stretch it. This will put more force on the rocker switch, and assure a better contact. You don't need to stretch it much.....probably 2-3mm. Note in the pictures above that the spring is barely seen under the ball bearing. Once stretched slightly, the spring should sit a higher in its mounting hole. Re-assemble the switch and test prior to re-installing. Plug the switch in and with the cart in NEAUTRAL, hold the plunger in and turn on the key. When plunger is released, your cart should turn over. Check this operation a few times prior to installation. Be sure to turn ignition key to the off position again prior to installation. When re-installing the switch, it is helpful to push the gas pedal down to align the bolts. You just saved yourself $50-$80 ........ Now go buy yourself a cold beer, and some other custom accessories |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-29-2016, 04:47 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Yamaha Stop Switch Repair
good idea, even if it turns out to be only a temporary fix... and while you are enjoying that beer, take a vacuum to that pedal area, you trying to start your very own forest in there? i have taken apart some of those, some have contact damage, but if you find that its still in salvageable condition- $68 in your pocket .
|
05-29-2016, 05:03 PM | #3 |
Gone Wild
Join Date: Feb 2009
Location: Ontario
Posts: 280
|
Re: Yamaha Stop Switch Repair
Ya she gets a little neglected under there.
I have done two of these switches now and have had zero issues so far (knock on wood) |
05-29-2016, 06:37 PM | #4 |
Gone Wild
Join Date: Oct 2012
Posts: 1,733
|
Re: Yamaha Stop Switch Repair
So have I. I had 2 fail as well. 70$ shipped cuts into the beverage fund
|
08-05-2016, 08:16 PM | #5 |
Not Yet Wild
Join Date: Aug 2016
Posts: 1
|
Re: Yamaha Stop Switch Repair
My cart just died. Wonder if symptoms are the same? I made a turn and and pushed pedal normally. Cart went forward a 20 or 30 feet and immediately lurched faster than normal. Eased off pedal and made another turn after stop sign and when gave some pedal nothing. Tried putting it in Tow, etc and nothing. Is this similar to what this stop switch could do?
|
08-07-2016, 08:20 AM | #6 | |
Gone Wild
Join Date: Feb 2009
Location: Ontario
Posts: 280
|
Re: Yamaha Stop Switch Repair
Quote:
|
|
02-21-2017, 06:49 PM | #7 |
Not Yet Wild
Join Date: Jul 2015
Location: Louisiana
Posts: 37
|
Re: Yamaha Stop Switch Repair
Cheesy, thanks for posting this. It looks easy enough to do and I am having an intermittent starting problem- may as well start with the easy cheap stuff first
|
02-21-2017, 06:52 PM | #8 |
Gone Wild
Join Date: Feb 2009
Location: Ontario
Posts: 280
|
Re: Yamaha Stop Switch Repair
No problem sir! Glad to share! Hopefully that's your issue, as it's a quick simple, and cheap fix!
Edit.... Should state.... my cart has still not had an issue since time of posting this thread |
02-21-2017, 08:43 PM | #9 |
Gone Wild
Join Date: Dec 2009
Location: Corpus Christi, TX
Posts: 1,644
|
Re: Yamaha Stop Switch Repair
Why do we have this switch?
Would it be easier to bypass it, if it keeps failing? |
02-22-2017, 06:13 AM | #10 |
Gone Wild
Join Date: Feb 2009
Location: Ontario
Posts: 280
|
Re: Yamaha Stop Switch Repair
Without it, your cart would be at idle as soon as key is turned on. Some people here have bypassed their switch. To me, that defeats the purpose of owning a golf cart, as it was designed for the continuous stop and go.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G9 Start Stop Switch | Gas Yamaha | |||
Accelerator Stop Switch | Gas Yamaha | |||
G1 Stop Switch | Gas Yamaha | |||
Yamaha G2/G8/G9 Stop Switch | Golf Carts and Parts | |||
stop switch g1 | Gas Yamaha |