Controller pin out test

[dtide]

I have a g29 with Moric controller jw2-h5610-01
Problem no solenoid click need wiring diagram or better a pin out test guide can anyone help me with this
It has good batteries and a new solenoid

[Volt_Ampere]

Search for the owner's manual - there is a schematic in there showing the connector pinout. Check for power at the key switch (3 amp fuse can be blown) There should be battery power the solenoid small terminal. The controller grounds the other side to energize the solenoid. There is a switch on the throttle that has to close to tell the controller the throttle is pressed.

[dtide]

Fuse is good throttle switch is good solenoid is not being grounded does have power

[dtide]

I found the diagram i need help with what the voltages should be

[Volt_Ampere]

My experience with Moric controllers is all bad. Both of my G29's have Alltrax controllers after the Morics failed. Does the solenoid click when you flip from Tow to Run? Does it click and resist motion if you push the cart. (run/tow in run position) All of these things can help you diagnose the problem.

[dtide]

It does neither

[Volt_Ampere]

Then if your fuse is good, it sounds like you have a dead controller.

[dtide]

Thats what i was thinking but was hoping to find a test so i could be sure

[Volt_Ampere]

Only test I know of is to swap in a known good unit. :-( No real diagnostics available that I have seen for Moric. If you need a new controller don't replace it with a stock Moric unless you get one dirt cheap. Get an aftermarket controller like Alltrax. Solid unit and it comes with great diagnostics built in via USB.