It is better to give then to recieve

[SCTurkeyHunter1]

Thanks for sharing

[Dela]

Originally Posted by Alexcavs7

I just bought this speaker and I don't understand how you attached it to the floor Mat in your first pictures? If you could explain or show pictures that would be much appreciated! Thanks

Alex - sure thing. I had originally "attached" it to the floormat by simply hooking stand of speaker around back of mat after pulling mat out a bit.

What I did after that (I wasn't crazy about trusting gravity to be on my side) was take out the cup holders as you can see in the pic. On the speaker box there are a few star metric screws that hold the unit together. I found longer screws close to the same thread at HD - drilled holes through cupholder and attached the speaker to the bottom of the cupholder using the threads already formed in the speaker box. It holds like Mike Tyson's grip.

Let me know if you need anything else -

[Alexcavs7]

Well I would do the screw install except for occasionally I might eat to take it out and use it just as a speaker or for on the boat or something. I must just be stupid haha. I'm sitting here and I puller the rubber floor mat and I'm trying to hook it into it in all ways but it just falls over and looks nothing like yours. I have a carbon fiber dash kit installed and idk if that makes any difference but I just can't seem to figure it out.

[Alexcavs7]

Want* not eat haha

[Dela]

Ahh.. When I had it hooked over the floor mat I also used high grade velcro to hold it in place. Two strips on top right over screw holes - then would push it up into the dash. It held ok and never fell but I wanted it more permanent.

I hear ya about wanting to use it elsewhere but I bought it just for that purpose.


edit - you can still see where the velcro was in pic 4 above

[Alexcavs7]

Idk what to do. I try to put it on the floor may but it just bends too much and it falls off. Ugh what kind of cart do you have?

[Dela]

If you don't want to mount it, there aren't many other options. Basket maybe?

EZGO Medalist (TXT)

[bigpoppi]

Just wondering, if there is a dual speaker mount, that'll fit under the cup holders at an angle like you originally had the Logitec speakers...I have the amp and dual 6-1/2's enroute to install.. and looking at your set up, figured someone would have moched up speaker mounts under the cups....?

[Dela]

Haven't seen that Poppi - but you could probably mock it yourself. I'd have to go measure the cup holder tray, can you cut out and mount the speakers to the bottom of the tray?

Be careful, the one con about this location is that dripping drinks in cup holders will get moisture on your speakers if not covered.



Diggin those white on white seats btw

[bigpoppi]

Figured if I mocked up a speaker placement below the cup holder, I'd have to devert the 'condensation drips' away from the speaker backs. that, or create a whole new dash out of fiber glass, with cup holders the size of kuzy's...



Sitting on the lot, the cart had tan seats and top, told him to exchange it w/the white.. I liked the look of the black and white better,,,, tx