No rev buzzer and intermittent click no go

[PuttPutt]

Hello to all, not sure what year ezgo this is can only find a serial # which is 2293734. No plate in glove box. Owner/neighbor thinks it is an 07.
36V FW switch is on the dash PDS.
1. No back up buzzer found the red wire disconected at the buzzer under dash reconnected and still no buzzer. I'll hook my meter to the buzzer wires and see if I getv a reading when in rev.
2. Sometimes clicks but no go.

While tracing the red wire from buzzer found this (pic below) so from the heat damage I'm guessing a new solenoid is in order. Or is there some other problem causing the heat?

[rib33024]

Is the battery cable melted or just the blue wire??



Search Results 2293734

Model Year: 2005 Make/Model: TXT Standard (PDS)

[camaroluvz28]

Looks like a loose connection caused some good heat damage...I would replace main positive wire to solenoid, solenoid, and any of the smaller wiring that has heat damage as preventative maint measure...

[PuttPutt]

Originally Posted by rib33024

Is the battery cable melted or just the blue wire??



Search Results 2293734

Model Year: 2005 Make/Model: TXT Standard (PDS)

small red wire has most of heat damage however the positive cable end has some plastic melted also.

[PuttPutt]

Originally Posted by camaroluvz28

Looks like a loose connection caused some good heat damage...I would replace main positive wire to solenoid, solenoid, and any of the smaller wiring that has heat damage as preventative maint measure...

Thats the direction I was heading now to figure out the rev buzzer.