Alltrax software settings

[MYCART8A4RE]

2016 48v sepex i2, eric charger (JE1611) stock motor, 18" tires

Hi folks, recently installed an XCT400, SW180 solenoid and 2ga cables that I got from Scottyb. At first my cart wouldn't go over 12mph and there was quite a delay between depressing the pedal and the power coming in. The cart would move forward but very slow and then after 2-3 seconds I would feel the torque come in. So I hooked up the laptop with the Alltrax software and noticed the FN2 option was selected, I wasnt sure if this was the way it needed to be knowing I didn't have the FN2 but thought it had to be there for some reason. For kicks I opted for the dual switch setting since it said "default" there, went out and everything was good. Running 23mph now with the torque nice and strong right out of the gate. I was thinking maybe some of the other settings might possibly be off as well and was hoping somone could take a peek and see for me. I would greatly appreciate it!

[WalterM6]

The only thing I would change is the throttle rate. Increase it to about 50-75%.

[MYCART8A4RE]

Thank you, I appreciate your input!