|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
03-24-2009, 03:43 PM | #11 |
Ban Puppy Mills & Stores!
Join Date: Dec 2008
Location: SE Florida
Posts: 2,955
|
Re: IQ Speed Setting Question
too quick on the trigger again...
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-24-2009, 03:54 PM | #12 | |
Ban Puppy Mills & Stores!
Join Date: Dec 2008
Location: SE Florida
Posts: 2,955
|
Re: IQ Speed Setting Question
Quote:
Click on the link in my previous thread to see actual pictures of the install. It's very easy and should take under 1 hour as long as the motor isn't stuck on the spline shaft. If that is the case a good rubber mallet tapping the end of the motor towards the differential should help loosen it. Make sure you disconnect your main negative and positive lead from the battery pack which should be the positive front most battery on the drivers side/left and the negative front most battery on the passenger side/right. There are only 4 bolts holding the motor on along with 4 wire terminals attached to the motor. Just make sure you jot down where each wire goes, just in case of a possible mental lapse, (happens with age sometimes... or was it the booze?!?!?) |
|
03-24-2009, 04:13 PM | #13 |
Gone Wild
Join Date: Oct 2008
Location: Wildwood, FL
Posts: 742
|
Re: IQ Speed Setting Question
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2003 club car IQ DS speed setting | Electric Club Car | |||
Sparkplug and Gap Setting | Gas EZGO | |||
Valve setting on 16hp clone? | Big Block Talk! | |||
G1 Carb Setting Issue? | Gas Yamaha | |||
points setting | Gas EZGO |