|
05-28-2012, 02:55 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2011
Posts: 4
|
1993 CC won't fire
1993 club car has been running fine with the exception of having to charge 12v battery after about 2-3 hours of use(assume the generator is not working). the other day it stopped doing anything as it always does when the 12v battery get low. charged the battery and still nothing. I have 12.8 volts at the battery and where the battery hooks up on the solenoid. starter side of solenoid has nothing. small terminals of the solenoid have 12.8 volts when key is in the on position. tried jumping battery side of solenoid to starter side and nothing happened. the solenoid had been making a clicking noise but has since stopped that. I checked the fuse and it also appears to test as good. any other ideas of what I should try from here? also what can I do to fix my charging issue? my kids are begging you to help me....
 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
06-04-2012, 12:43 PM
|
#2 |
|
Not Yet Wild
Join Date: May 2011
Posts: 4
|
Re: 1993 CC won't fire
anyone?
|
|
|
|
|
06-04-2012, 12:54 PM
|
#3 |
|
Gone Wild
Join Date: Jan 2011
Location: Las Vegas, Nevada
Posts: 1,942
|
Re: 1993 CC won't fire
Sounds like your starter/gen needs replaced or rebuilt. What starts the engine also charges the battery.
|
|
|
|
|
06-04-2012, 01:30 PM
|
#4 |
|
The Last Moja Morani
 Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: 1993 CC won't fire
are you sure the fuse is good? if so make sure your dealing with a good fully charged battery and than see what happens.....if nothing then jump the 2 large post on the solenoid see if it cranks over if so its either the microswitch in black box or solenoid..............while in there change voltage regulator and cart will charge...........................................8 )
|
|
|
|
|
06-04-2012, 05:13 PM
|
#5 |
|
Not Yet Wild
Join Date: May 2011
Posts: 4
|
Re: 1993 CC won't fire
I swaped the fuse and still nothing....i have 12v at the battery end of solenoid but when I cross it from battery to starter across the solenoid I get nothing...battery tests 12.8v...any other test i can do with the tester? also i was told if the battery will maintain charge it is the starter/gen?
|
|
|
|
|
06-05-2012, 10:13 AM
|
#6 |
|
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: 1993 CC won't fire
so if you lay a wrench across the big terminals of solenoid it still won,t crank over?? if thats the case pull a few of the rubber inspection boots on starter and see how far down brushes are.................................
 |
|
|
|
|
06-10-2012, 12:55 PM
|
#7 |
|
Not Yet Wild
Join Date: May 2011
Posts: 4
|
Re: 1993 CC won't fire
will not do anything when crossing over solenoid...has 12.8v on battery side of solenoid....not sure what I am looking for on starter brushes?
|
|
|
|
|
06-11-2012, 07:21 AM
|
#8 |
|
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: 1993 CC won't fire
the wear? if they are worn down to much the springs don,t put enough pressure on them to make good contact with armature hence the starter won,t turn over......there are minimum wear lines on brushes if you can,t see them then they are already down in the holder and worn out..............................
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| My First Fire | Electric Club Car | |||
| Ez-go txt no fire | Gas EZGO | |||
| G2 No fire | Gas Yamaha | |||
| Ez Go On Fire | Electric EZGO | |||
| No Fire | Big Block Talk! | |||
Linear Mode
