EZGO will not go

Martianjump82 · 03-20-2020, 12:10 PM

I have a 2007 36 volt EZGO that I am unable to get to move in either forward or reverse. It was working last night and the batteries were weak. I plugged it in and charged it all night. Go on it this morning and there was a slight bump when I pressed the accelerator pedal down but nothing else.

rockfordpi · 03-20-2020, 12:32 PM

Quote:

Originally Posted by Martianjump82

I have a 2007 36 volt EZGO that I am unable to get to move in either forward or reverse. It was working last night and the batteries were weak. I plugged it in and charged it all night. Go on it this morning and there was a slight bump when I pressed the accelerator pedal down but nothing else.

What is the battery voltage of the entire pack when fully charged? Also, measure the battery voltage when you push down the pedal.

Where on your cart if the F/R switch located?

Martianjump82 · 03-20-2020, 12:52 PM

36 volts and the switch is under the passenger

Martianjump82 · 03-20-2020, 12:53 PM

The solenoid was clicking but has stopped

rockfordpi · 03-20-2020, 05:55 PM

Quote:

Originally Posted by Martianjump82

36 volts and the switch is under the passenger

Just to be clear, the Forward - Reverse switch is under the passenger? The reason I need to be sure of that is we need to ascertain which type cart you have.

Fully charged batteries should be reading more than 36v, but that still should be plenty to close the solenoid.

Martianjump82 · 03-23-2020, 08:57 AM

I have a series golf cart. The solenoids are clicking and the forward and reverse switch is in good condition. There is not a tow switch

rockfordpi · 03-23-2020, 09:54 AM

Quote:

Originally Posted by Martianjump82

I have a series golf cart. The solenoids are clicking and the forward and reverse switch is in good condition. There is not a tow switch

Measure the voltage on each of solenoid terminals back to main battery negative when it is activated (Clicks). If no voltage on one of the terminals, Solenoid has failed.

If pack voltage on both, problem is further downstream with F/R switch, Motor, Controller components/circuit.

Martianjump82 · 03-23-2020, 11:02 AM

Thank you. I will check when I get my meter back.

03-20-2020, 12:10 PM	#1
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5	EZGO will not go I have a 2007 36 volt EZGO that I am unable to get to move in either forward or reverse. It was working last night and the batteries were weak. I plugged it in and charged it all night. Go on it this morning and there was a slight bump when I pressed the accelerator pedal down but nothing else.
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5

03-20-2020, 12:52 PM	#3
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5	Re: EZGO will not go 36 volts and the switch is under the passenger
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5

03-20-2020, 12:53 PM	#4
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5	Re: EZGO will not go The solenoid was clicking but has stopped
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5

03-23-2020, 08:57 AM	#6
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5	Re: EZGO will not go I have a series golf cart. The solenoids are clicking and the forward and reverse switch is in good condition. There is not a tow switch Last edited by Martianjump82; 03-23-2020 at 09:02 AM.. Reason: adding information
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5

03-23-2020, 11:02 AM	#8
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5	Re: EZGO will not go Thank you. I will check when I get my meter back.
Martianjump82 Not Yet Wild Join Date: Mar 2020 Posts: 5

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum