|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
07-10-2020, 03:39 AM | #1 |
Not Yet Wild
Join Date: Jul 2020
Location: Louisiana
Posts: 3
|
no power to ignition switch
I recently purchased an electric Yamaha G9 and it was running fine. I put a 4" block lift kit on it and now it will not run. I have triple check to make sure I didn't hit or pull a wire lose during the install. I have been troubleshooting if for days and found that I do not have power to either wire going into the ignition switch. This is an old cart so I'm not sure which wire should I be following or what supply the power to the ignition switch in the first place. one wire just dies into a fuse and the other wire goes up under the cart to the foot pedal. I'm lost! where does the Ignition switch get it's power from on the G9?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-11-2020, 06:18 PM | #2 |
Not Yet Wild
Join Date: Jul 2019
Location: Georgia
Posts: 10
|
Re: no power to ignition switch
download your wire diagram here:
http://www.courtesygolfcars.com/yamaha-schematics |
08-11-2020, 01:52 AM | #3 |
Not Yet Wild
Join Date: Jul 2020
Location: Louisiana
Posts: 3
|
Re: no power to ignition switch
Thanks got it running again!!
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
EZGO Ignition Switch Help (where to connect hot wire on Radio to Ignition Switch) | Gas EZGO | |||
2001 "Ignition Switch" power question | Electric Club Car | |||
1995 electric club car shorted ignition switch no power | Electric Club Car | |||
No power at ignition switch | Electric Club Car | |||
No power to ignition switch | Electric EZGO |