|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-13-2020, 08:53 AM | #1 |
Not Yet Wild
Join Date: Jun 2016
Posts: 19
|
No power to solenoid nothing when press gas
I have an 89 3pg. She was running great no issues after some help from this forum. I ran it for about 6 months and then decided to tear it down and paint. Never touched the motor did anything to it just took all the plastics off to paint. It did sit for quite sometime before I finished and finally started putting humpty back together but when I got ready to test drive nothing. No clicks not starter spinning nothing. I checked the pedal switch and it is good. I jumped the solenoid still nothing it is like she is dead. I cannot read wire diagrams no matter how hard I try I can't picture the paths so I don't know where to go from here.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-13-2020, 09:26 AM | #2 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,491
|
Re: No power to solenoid nothing when press gas
I'm going to guess at 2 possibilities here. Dead battery, or you accidently disconnected a major ground connection.
First things first. You need a digital multimeter. Battery voltage should be 12.74 volts for a fully charged battery. Did you remove the key switch for paint? |
07-13-2020, 09:32 AM | #3 |
Not Yet Wild
Join Date: Jun 2016
Posts: 19
|
Re: No power to solenoid nothing when press gas
I bypassed key switch when I first bought it.
|
07-13-2020, 05:33 PM | #4 |
Not Yet Wild
Join Date: Jun 2017
Posts: 44
|
Re: No power to solenoid nothing when press gas
if you jumped the solenoid and didnt get anything....it's a ground issue somewhere
|
07-13-2020, 05:38 PM | #5 |
Gone Insane
Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: No power to solenoid nothing when press gas
Did you jump the big posts or small posts?
|
07-13-2020, 08:31 PM | #6 |
Not Yet Wild
Join Date: Jun 2016
Posts: 19
|
Re: No power to solenoid nothing when press gas
big...
I did put power to the two small and it clicked so I think it is still good. |
07-14-2020, 02:37 AM | #7 |
Gone Insane
Join Date: Oct 2016
Location: Richmond, VA
Posts: 14,214
|
Re: No power to solenoid nothing when press gas
|
07-14-2020, 07:34 AM | #8 |
Not Yet Wild
Join Date: Jun 2016
Posts: 19
|
Re: No power to solenoid nothing when press gas
Any other thoughts... like I said nothing was touched other than sitting for a while.
I took a test light to the body of the starter gen and pos post of the battery and it lights so the starter is grounded. |
07-14-2020, 07:57 AM | #9 |
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,491
|
Re: No power to solenoid nothing when press gas
What is the battery voltage before and after stepping on the pedal?
|
07-14-2020, 10:53 AM | #10 |
Not Yet Wild
Join Date: Jun 2016
Posts: 19
|
Re: No power to solenoid nothing when press gas
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
1995 ezgo medalist power, new batteries, no power to the solenoid | Electric EZGO | |||
No Power at the Solenoid | Electric Club Car | |||
95' lost 99% power. Press accelerator and get slight bump. | Electric EZGO | |||
ezgo electric press pedal all the way losses power | Electric EZGO | |||
when i press pedal solenoid doesnt click issue | Electric Club Car |