|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-25-2014, 09:24 PM | #11 |
Not Yet Wild
Join Date: Mar 2009
Location: summerfield florida
Posts: 23
|
Re: Cart will not move
how big are the green and blue wires? small 18ga?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-25-2014, 09:46 PM | #12 |
Not Yet Wild
Join Date: Nov 2014
Location: New Mexico
Posts: 9
|
Re: Cart will not move
Where would I go for an entire rear axle?
Sarge |
11-25-2014, 09:47 PM | #13 |
Not Yet Wild
Join Date: Mar 2009
Location: summerfield florida
Posts: 23
|
Re: Cart will not move
those are for your ignition switch, there off of one of your micro switches. on the f/r switch. should be able to find a wiring diagram on here, to show you wich one
|
11-25-2014, 09:47 PM | #14 |
Not Yet Wild
Join Date: Nov 2014
Location: New Mexico
Posts: 9
|
Re: Cart will not move
can you go into my Album "MY EZGO? I added picture of both wires? I think they are both 18Ga?
Sarge |
11-25-2014, 09:49 PM | #15 |
Not Yet Wild
Join Date: Mar 2009
Location: summerfield florida
Posts: 23
|
Re: Cart will not move
I picked mine up at a small golf cart shop they have old carts the aren't going to use. I think I paid $40,00 for mine
|
11-25-2014, 09:50 PM | #16 |
Not Yet Wild
Join Date: Nov 2014
Location: New Mexico
Posts: 9
|
Re: Cart will not move
So would either one of those wires keep me from moving? It reeves up or whines really loud (no grinding) but won"t move? the F&R switch arm is moving and engaging the Switch for reverse polarity.....just seems like gears are not engaging?
Sarge |
11-25-2014, 09:51 PM | #17 |
Not Yet Wild
Join Date: Mar 2009
Location: summerfield florida
Posts: 23
|
Re: Cart will not move
yes, I seen the wires on your album. they power the solenoid when you turn the key on.
|
11-25-2014, 09:53 PM | #18 |
Not Yet Wild
Join Date: Mar 2009
Location: summerfield florida
Posts: 23
|
Re: Cart will not move
they must have ran new wires. if your motor is running
|
11-25-2014, 09:55 PM | #19 |
Not Yet Wild
Join Date: Mar 2009
Location: summerfield florida
Posts: 23
|
Re: Cart will not move
I would throw an oil pan under the rear end and pull the cover. think your gears are shot. mine were piled about an inch high about the width of a spray can top
|
11-26-2014, 07:33 PM | #20 |
Not Yet Wild
Join Date: Nov 2014
Location: New Mexico
Posts: 9
|
Re: Cart will not move
FOUND THE PROBLEM!!!!!!! DRIVER SIDE HUB COMPETELY WORN---NO GROOVES FOR SPLINE!
Finally found the problem on the EZGO that I paid $200 dollars for....it was a spun hub...found a junked EZGO at our local golf course and pulled the HUB from it, cleaned up nice and had no break grooves. After cleaning out the brake are which was full of metal dust from the hub teeth, installed the now cleaned hub....replaced wheel and BOOM we were rolling! Now it looks like I'm going to replace the brakes...takes a bit to stop her, peddle almost to the ground, maybe just need adjusting because both brake pads on both on rear showed a good amount of break pads? Also, we drove it for about 20 minutes and it started to shudder up our neighbors steep hill after going up it a few times so it lost power pretty quick...Im guessing it needs new batteries but we have a rolling 1994 EZGO Textron series cart....WERE STOKED!? SARGE Last edited by Tango1Down; 11-26-2014 at 07:35 PM.. Reason: mispelling |
|
|
Similar Threads | ||||
Thread | Forum | |||
cart won't move | Electric Club Car | |||
Cart Won't Move but Tries | Electric Club Car | |||
Cart Does not move at all | Electric Club Car | |||
Cart doesn't move | Gas EZGO | |||
My Cart Won't Move | Gas EZGO |