10-11-2016, 06:38 PM | #1 |
Getting Wild
Join Date: Jan 2012
Posts: 80
|
Help cart wont start
My golf cart has a fe350d-as10 engine installed in it. I removed the clutch bolted to the crankshaft. I didnt know it was reverse thread. So clockwise was loosen not tightened. Well ever since i put the clutch back on i think i had the bolt over torqued because the starter and belt would turn when you crank it but the clutch wouldnt turn to start it. So i loosened it up to get the clutch to rotate freely but i cant get the starter. Belt. And clutch to work properly to start the engine. What am i doing wrong? It worked perfectly fine before i took it apart. Please help
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-11-2016, 08:58 PM | #2 |
Gone Wild
Join Date: Sep 2015
Location: New Braunfels, TX
Posts: 178
|
re: Help cart wont start
I'm going to follow this one
|
10-12-2016, 06:21 AM | #3 |
What the ....?
Join Date: Jan 2007
Location: N.E. Wisconsin
Posts: 14,932
|
re: Help cart wont start
The drive clutch needs to be tight on the crankshaft! (torque to 25 ft lbs.)
Tighten, or replace your starter/generator belt! |
|
|
Similar Threads | ||||
Thread | Forum | |||
cart wont start | Gas Yamaha | |||
gas cart wont start | Gas Club Car | |||
G1 my first cart wont start Help | Gas Yamaha | |||
cart wont start | Gas Club Car | |||
Cart wont start | Gas EZGO |