|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-13-2018, 02:08 PM | #1 |
Not Yet Wild
Join Date: Jul 2018
Location: Denver, NC
Posts: 47
|
GX340 crankshaft too short???
I'm dropping a Honda gx340 into my txt. I'm planning to purchase the v-belt pulley for the S/G from Vegas Carts. I currently have a Comet 780 drive clutch. The engine crankshaft is 2 13/64" long, the clutch already stops an inch or so short of going all the way onto the shaft, if I add the pulley I'll subtract another inch or so from how much the clutch slips onto the shaft. Thoughts?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-13-2018, 11:35 PM | #2 |
Not Yet Wild
Join Date: Jul 2018
Location: Denver, NC
Posts: 47
|
Re: GX340 crankshaft too short???
Ok so I pulled the motor out, pulled the clutch off and re-measured everything. My distance between the flange and end of shaft is actually 2.75” (in contradiction to the online manual). So I think my shaft is just long enough...
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Honda GX340 | Clone Engine Swaps | |||
gx340 or gx390 | Big Block Talk! | |||
Wanted: G2 Crankshaft or Short-Block | Golf Carts and Parts | |||
16hp Vanguard Crankshaft Too Short??? | Big Block Talk! | |||
Honda GX340 | Clone Engine Swaps |