G22a rear end switched with a g27aqq

[redtide361]

Hey hopefully someone can give me a legitimate answer on this. I have a 06 g22 with a blown out rear-end. I found a 06 g27 with a rear-end that works. Will the g27 rear-end match and mount to my g22. I'll post the pictures on a reply.

[redtide361]

Here they are

[cgtech]

I believe it will be a direct bolt-in in every way. Except the gear ratio difference noted in the other thread.

[redtide361]

You are correct it was a direct bolt on however the only other differences in frame is the g22 had 11" measurement from center to center of A-arm mounts. On the g27 it measures 12". And the rear shocks are longer not the mounts just the shock. Also the back bumper area where the panhard arm connects has a 7" long tab, the g22 is at 2-3 inches as to where the jakes 6" spindle drop lift kit adds a bracket to make the g22 11" long. I'm being very thorough to help someone. Because I have been helped a few times thanks to this community.

[redtide361]

Can also use the g22 front end but not rear. Rear frame on the g27has the mounts for the dump bed which would require cuts being made on the rear cowling.