High Gearing

[goldwinger]

Im wanting to put a high speed rear end in my 2000 Club Car that has a Fe290 engine in it..can anyone tell me where I can get one and if it works on a cart that has been lifted 6 inches..please tell me the pros and cons of this issue..safety issues????

[illregal]

You can get them from just about all the vendors. Check out cartpartsplus. It's an internal part, so should work with any lift using a stock rear end.

Benefits: faster top speed, lower engine revs
Cons: lose torque, and possibly the ability to go up hills depending on hill and load. Probably more likely to roll because you're going faster.

I'd probably use a 10:1 or an 8:1 ratio. Unless you plan to run a big block in the future there is also a 6:1.

I plan on doing mine over the winter.