HEI Conversion 2001 Ezgo Text

[unezgo]

I have a 2001 Ezgo Workhorse 800. Was getting hard to start. Weak plug fire and sometimes no fire at all. Have done HEI upgrade. Wired up explicitly as previous instructions by jeffrun on forum. Replaced solenoid,new pulsar set at .030,new voltage regulator,new early GM HEI module '74 Chevy trk 350,which is mounted to frame via aluminum 1\4 in. plate,all terminals and surfaces well cleaned and well grounded with new bolts. Grounded test light to coil lights up,but does not flash and no fire to plugs. Everything ohms out okay except coil primary which i'm told should be about .5 is 5.2 on my not very old ignition coil. Is this indicative that my coil is bad and is there anything else I need to be looking at? Was very excited and motivated by concept of HEI upgrade,but after two weeks fighting this thing,I am very disappointed. Any help and or advice would be greatly and deeply appreciated. Thanks