|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
07-19-2017, 08:27 AM | #1 |
Not Yet Wild
Join Date: Feb 2017
Posts: 30
|
XCT 400 wiring to motor
Hey guys. Got a question. On my B+ side on the controller i have pack voltage.... but at my A2 motor post i'm only getting 17volts. On my M- I only have 20 volts coming out and at the A1 post I have 5 volts. This is with the throttle depressed or not. Just seems odd to lose voltage directly across the cables. The Cable are 4awg with and they are ALL lest than 2 months old. Any help would be greatly appreciated.
Thanks, Chris |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-19-2017, 09:36 AM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,358
|
Re: XCT 400 wiring to motor
I think you may be chasing your tail here. Lets go back to your original thread and solve the controller fault code issue first.
|
07-19-2017, 12:51 PM | #3 |
Not Yet Wild
Join Date: Feb 2017
Posts: 30
|
Re: XCT 400 wiring to motor
I cant get it to throw a code anymore. I tested everything in the low circuit. All switches are good. I thought it was the ITS so i swapped it out with another but the problem persisted. F/R switch is good. Micro switch is good. Key switch is good. Solenoid clicks..... I'm assuming its in the high circuit. Battery pack voltage is also good and motor tested good.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
PDS motor wiring | Electric EZGO | |||
wiring to motor | Electric Club Car | |||
95 txt dcs motor wiring | Electric EZGO | |||
Wiring on Motor | Electric EZGO | |||
G2E motor wiring and everything | Golf Carts and Parts |