G29 bent rear drivers side axle, looking for used part

[matthd24]

Originally Posted by TubbyPtown

Good to hear! I really appreciate everyones help. After calling about 30 yamaha dealers across the tri state area, a place called golf cart solutions in Collinsville, TX thinks they might have a rear axle. But they close at 5 so they will have to check tomorrow (bummer).

I think I found one

https://discountcartparts.com/dcp/ya...arts/7708.html

[Golf cart guy]

Originally Posted by matthd24

This is good to know ! Yeah as long as you keep your fluid changes I bet they will
Last a long time !

Have you ever done gears in the team transaxle ? Just wondering how hard it is to do?

Thanks

Ive put high speed gears in them and the only failure Ive had is axle seals and rear axle bearings.

[matthd24]

Originally Posted by Golf cart guy

Ive put high speed gears in them and the only failure Ive had is axle seals and rear axle bearings.

Pretty easy to install high speed gears ? Have never seen a break down of someone doing it with picture!

[cgtech]

It's the most labor intensive HS gear job I know of. I have installed many & dont like them, have seen the teeth come off the thin ring gear.

[matthd24]

Originally Posted by cgtech

It's the most labor intensive HS gear job I know of. I have installed many & dont like them, have seen the teeth come off the thin ring gear.

Is that because it a cheap gear set ? Where did you get them from that the teeth were coming off ?

[Golf cart guy]

Originally Posted by cgtech

It's the most labor intensive HS gear job I know of. I have installed many & dont like them, have seen the teeth come off the thin ring gear.

Yikes, I was going to say its the easiest high speed gear change ever. I know in early 2007-2008 there were some cheap china gear sets that the teeth would go bad. I never installed any those. There are great gear sets out there now with no issues. Im in the villages, where every gas cart has high speed gears.

[cgtech]

They are from the usual source, the same place nivel gets theirs. And I say most labor intensive because the axle has to be split, and there is a good possibility of not getting the brake basket all the way back in if done by inexperienced people.