|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
02-27-2020, 02:45 PM | #1 |
Not Yet Wild
Join Date: Feb 2020
Posts: 5
|
Wont stop beeping and wont move
I have a 1998 Txt DCS cart and cart will not stop beeping and will not move. Continues to beep even with key off unless put in tow mode. Switch to run with key on or off and just get continuous beeping and will not move? Any help or ideas would be greatly appreciated.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
02-27-2020, 02:56 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Wont stop beeping and wont move
Possible corrosion in the harness, or possible failed controller.
|
02-27-2020, 03:32 PM | #3 |
Not Yet Wild
Join Date: Feb 2020
Posts: 5
|
Re: Wont stop beeping and wont move
have 39.6 volts getting to solenoid however when in run mode cant seem to get any voltage out of solenoid. When in tow mode shows 36 volts out of solenoid?
|
02-27-2020, 04:00 PM | #4 | |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,417
|
Re: Wont stop beeping and wont move
Quote:
Does the solenoid click? Is there 36v measured between the 2 small solenoid posts when you try to go? |
|
02-27-2020, 04:53 PM | #5 |
Not Yet Wild
Join Date: Feb 2020
Posts: 5
|
Re: Wont stop beeping and wont move
Not sure what you are referring to when you say solenoid resistor. I will check voltage across small terminals
|
02-27-2020, 04:56 PM | #6 |
Not Yet Wild
Join Date: Feb 2020
Posts: 5
|
Re: Wont stop beeping and wont move
No sir no voltage across small terminals
|
02-27-2020, 05:04 PM | #7 |
Not Yet Wild
Join Date: Feb 2020
Posts: 5
|
Re: Wont stop beeping and wont move
Solenoid does not click when trying to run
|
02-27-2020, 06:41 PM | #8 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: Wont stop beeping and wont move
More than likely a blown controller. Replace it with an Alltrax XCT48400 or larger.
FWIW: The solenoid's battery side large terminal is connected directly to the battery pack's main positive terminal and should read battery pack voltage whether the Run/Tow switch is in Run or Tow and and the controller side large terminal ought to read slightly less than pack voltage regardless of Run/Tow switch status, if precharge resistor/diode assembly is installed Attachment-1 is schematic for DCS drive. Attachment-2 is picture of precharge resistor/ diode assembly. |
|
|
Similar Threads | ||||
Thread | Forum | |||
Ezgo beeping continuously and wont charge | Electric EZGO | |||
Motor wont stop | Electric EZGO | |||
96 club car ds solenoid wont click and cart wont move unless you jump solenoid | Electric Club Car | |||
Ezgo dcs solenoid clicks but wont disengage and wont move | Electric EZGO | |||
EZ GO wont stop | Electric EZGO |