|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
03-23-2019, 04:39 PM | #1 |
Not Yet Wild
Join Date: Apr 2017
Posts: 5
|
36v ezgo txt non-pds solenoid clicks, can does not move
2006 ezgo txt non-pds Curtis 36v controller 5 pin connector (w,b,o,r) only used others are empty.
B+ to B- pack volts B- to M- 1.6 volts no pedal, key on B- to M- .6 volts with enough pedal to click solenoid B- to M- down to 0 volts with full pedal, key on Wire moved from M- to B- terminal nothing happens New solenoid New ITS Any assistance please would be greatly appreciated. Regards Paul |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-23-2019, 05:21 PM | #2 |
Gone Mad
Join Date: Oct 2009
Location: Buford, GA
Posts: 8,988
|
Re: 36v ezgo txt non-pds solenoid clicks, can does not move
If your solenoid clicks, all of the wires (small) are OK, with the possible exception of the ITS wires/spade connectors/Molex plug.
See if yours has a four wire Molex connector on the cable that goes from the throttle box to the wiring harness, usually located between the FNR and the controller/solenoid, see pic. If it does, eliminate this plug by butt splicing or soldering then quality heat shrink. If this doesn't fix it, your problem lies in the high current circuit - controller, batteries, FNR, solenoid, motor, and all cables and connections. If you download the repair/service manual from the Stickies, there is a very detailed troubleshooting guide in chapter E. |
03-23-2019, 05:56 PM | #3 |
Not Yet Wild
Join Date: Apr 2017
Posts: 5
|
Re: 36v ezgo txt non-pds solenoid clicks, can does not move
I have the moles bypassed still no movement, given the cables, FNR, batteries, solenoid are new that leaves the motor and controller.
Is there a way to definitely confirm the controller is bad or the motor? As putting M- to B- did not spin the motor. |
03-23-2019, 07:07 PM | #4 | |
Gone Mad
Join Date: Oct 2009
Location: Buford, GA
Posts: 8,988
|
Re: 36v ezgo txt non-pds solenoid clicks, can does not move
Quote:
Do you have a wiring diagram and know how to read it? |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
96 EZGO Fully charged, solenoid clicks will not move | Electric EZGO | |||
EZGO solenoid clicks and won't move is it F/R switch? | Electric EZGO | |||
97 or 98 EZGO TXT won't move, solenoid clicks | Electric EZGO | |||
1995 ezgo solenoid clicks but cart won't move | Electric EZGO | |||
91 ezgo solenoid clicks, wont move | Electric EZGO |