|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
05-07-2021, 08:29 PM | #1 |
Not Yet Wild
Join Date: Apr 2021
Posts: 8
|
1998 Club Car 48V Regen II Controller Help!
I have replaced just about every electrical component on this Club car that I rescued from an auction.
I have been all over this forum and the search feature has helped me a lot. I have gotten everything working, except it wont MOVE. With the tow stich to Run, Key on, I press the "gas" (GO pedal) and I hear the clicks of the solenoid, but no movement. Iv tested the motor with a 12v battery, and she moves fine. I am thinking my issue is with the Controller. I would like to test the output side of the controller, but it doesnt seem very intuitive. My B- and B+ read a few volt shy of pack voltage until I press the gas, and then it reads pack voltage (49.9). So the input seems fine. All batteries are brand new. Additionally the OBC is bypassed. I get reverse buzzer etc. I have also tested the FNR switch and it seems to be working normally. Literally every other thing is new on the car minus the motor and controller. Replaced every connecter with a new one. If you need more information, please ask. I can also send some pictures if needed. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-10-2021, 10:56 AM | #2 |
Not Yet Wild
Join Date: Apr 2021
Posts: 8
|
Re: 1998 Club Car 48V Regen II Controller Help!
Well i ordered a new controller from Revolution. I guess we will see.
|
05-11-2021, 03:11 PM | #3 |
Gone Wild
Join Date: Dec 2016
Location: Kingsland, Georgia
Posts: 1,825
|
Re: 1998 Club Car 48V Regen II Controller Help!
Welcome to the forum. It appears you already received a wealth of knowledge from this forum.
I'm sorry for the lack of response. Occasionally members who can assist with Club Cars are unavailable. What you'll find here though, are genuine people who really spend a lot of time trying to help. I couldn't have done it without them. BTW, did you replace the solenoid? If not, I would get one of those also. I believe you have been steered in the right direction by David Hick @ Revolution. Please continue this thread when you get the controller and have it running. We can all learn from your experiences. Good luck! |
05-16-2021, 09:32 AM | #4 | |
Not Yet Wild
Join Date: Apr 2021
Posts: 8
|
Re: 1998 Club Car 48V Regen II Controller Help!
Quote:
Also, i just realized today that i only have one diode across the large terminals, and not the suppression diode across the small ones. Could that be the cause? When installing the Alltrax Controller, i was instructed to remove the "drivers Side' Solenoid and tape up the wires. Nothing worked until I connected the orange/white and brown wires that connected to the small post of that Solenoid. Anyone have experience with that? did i do that correctly? |
|
05-16-2021, 03:38 PM | #5 | |
Gone Wild
Join Date: Dec 2016
Location: Kingsland, Georgia
Posts: 1,825
|
Re: 1998 Club Car 48V Regen II Controller Help!
Quote:
I don't think the diode not being on the coil will cause the regen circuit to not work. When you redid everything on the cart, did you replace the wiring harness to convert to IQ? The new wiring harness would take care of the drivers side solenoid removal, and regen wiring. David Hicks has the wiring harnesses for your cart. Do not buy them anywhere else. Non-OEM harnesses require a LOT of reworking to make them function correctly. And they cost over $240.00. The OEM is less than 1/2 that. Ask me how I know this! |
|
05-16-2021, 04:09 PM | #6 | |
Not Yet Wild
Join Date: Apr 2021
Posts: 8
|
Re: 1998 Club Car 48V Regen II Controller Help!
Quote:
Also where should i contact David Hicks at? It's this revolutionary carts where i got the alltrax controller? Sent from my SM-N975U1 using Tapatalk |
|
05-16-2021, 05:37 PM | #7 | |
Gone Wild
Join Date: Dec 2016
Location: Kingsland, Georgia
Posts: 1,825
|
Re: 1998 Club Car 48V Regen II Controller Help!
Quote:
Anyway, David will tell you what you need. Since he sold you the controller, he must know what you have. |
|
05-17-2021, 07:51 AM | #8 | |
Not Yet Wild
Join Date: Apr 2021
Posts: 8
|
Re: 1998 Club Car 48V Regen II Controller Help!
Quote:
|
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
1998 club car 48v regen with GE controller H4D222C1 | Electric Club Car | |||
"WTB - Good Regen 2 Controller 1998 Club Car DS | Golf Carts and Parts | |||
1998 CC Regen 2 - Installed New Controller, still no movement | Electric Club Car | |||
1998 club car 48 v regen | Electric Club Car | |||
1998 48 volt regen club car | Electric Club Car |