|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
04-03-2012, 03:51 PM | #1 |
Not Yet Wild
Join Date: Apr 2012
Posts: 4
|
Setting toe on a G-16
Hi Everyone, I need to set the tow-in on my G16 to 1/8" from what i read on this site but don't know how to do that. Any help would be appreciated.
Thanks in advanced |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-03-2012, 11:32 PM | #2 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: Setting toe on a G-16
Big, drive the car about 15 feet forward in a straight line. I get a piece of 1x2, about 24" long. I hold one end of the board on the bead area of the wheel, spindle high, and measure to the bead of the other wheel with a tape. Loosen all 4 tie rods nuts. One nut on each rod is left hand thread. There should be about the same number of threads showing on each of the 4 tie rod ends. Measure in front (spindle height) then in back of the front wheel (spindle height). The rear should be an eighth inch longer.
|
04-04-2012, 05:48 AM | #3 |
Not Yet Wild
Join Date: Apr 2012
Posts: 4
|
Re: Setting toe on a G-16
Thanks for the info mike I'm going to try that today
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
re-setting the obc | Electric Club Car | |||
The different setting for PDS can someone explain? | Electric EZGO | |||
IQ program setting on DS | Electric Club Car | |||
the 27 hp kaw. is setting in the c.c. | Big Block Talk! | |||
points setting | Gas EZGO |