|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
08-31-2009, 11:46 AM | #1 |
Not Yet Wild
Join Date: Aug 2009
Posts: 1
|
Trying to replace ignition but existing is 5 prongs
Hello,
I have a Club Car Pioneer (gas). The key wasn't working to well and I went to replace the ignition. The existing ignition has three position (off, run, start) I went to a local boat dealer and got a three position ignition and it has three prongs in it. I pulled out the existing ignition and it has 5 prongs (all with wires attached) I cannot figure out how to replace this or find a 5 prong ignition switch for it. I went back to the boat dealer and his five prong switches had too many modes (off, run, start, accessory). I have attached an image of the old ignition. Thanks for your help. I have been searching all day and havn't found anything yet - you are my only hope! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-31-2009, 12:14 PM | #2 |
Not Yet Wild
Join Date: Aug 2009
Posts: 10
|
Re: Trying to replace ignition but existing is 5 prongs
i have that same one... i found one in an old murry ride on lawn mower.. it worked for me give that a shot...
|
Tags |
5 prong ignition, club car pioneer ignition, ignition |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Replace cables | Electric EZGO | |||
Replace resistors or not??? | Electric Club Car | |||
If I was to take my FE290 out and replace it with a FE350 | Gas EZGO | |||
Controller replace question | Electric EZGO | |||
Replace clutch 2002 gas txt | Gas EZGO |