97 txt dcs problem

[palomba16]

Just bypassed the reed switch and when I turn key on the buzzer turns on and stays on until I press pedal then stops but no movement in f/r. If I turn it back to neutral it stops. When I press pedal I hear the solenoid click but that's it. I took cover off to inspect solenoid and found that one of the cables running to motor was burnt completely off. On one side at the big post. And a little bit burn at the run/tow switch but still intact. Waiting on a new solenoid, replaced cable already. Is this make sense to anyone?

[kgsc]

Last time I saw one like that was after someone had towed a cart with the Run/Tow in Run. Melted the solenoid and cooked the wire. Possible ? The symptoms you are having are pointing towards a fried controller..

[palomba16]

So once the solenoid is replaced and I turn the ignition on if I hear the buzzer in any position besides reverse it's my controller?

[kgsc]

Not saying that 100%. If you are getting the reverse buzzer in F and R, I would check to make sure your FnR micro switches are working properly. If so, I know the PDS cart controller is what tells the buzzer to come on so I am assuming the DCS is similar. That said, if it is alarming all the time it has is dues.

[palomba16]

I want to say it's going off in neutral as well.

[scottyb]

It sounds like the controller is ALWAYS in reverse regardless of the directional switch input then?

[palomba16]

But when I press pedal it stops like tripping a breaker.

[palomba16]

Ok installed new solenoid. Hooked batteries back up waited to switch to run then turned on ignition. That's when beeping started in any position. It will stop beeping if I switch to tow or by pressing pedal. Any ideas?

[Doctord]

This all started right after you bypassed the reed switch, where did you run that line to?

[palomba16]

Well nothing worked when I got the cart. I put 3 12 volt batteries in it and then checked the reed switch because only getting lights. So yes, I'll upload pictures.