|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
09-09-2016, 03:37 AM
|
#1 |
|
Not Yet Wild
Join Date: Mar 2011
Location: Sex Juice Ohio
Posts: 41
|
01 EZGO Won't Go need Help !!
this is a 36volt cart, i have Checked voltage on all my batteries an the connections every battery is fully charged, the cart will start to move forward or reverse but it has no power if i jack it up it will run forward or reverse (how can I test the Speed controller or Motor to find my problem the cart was running fine..
 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
09-09-2016, 08:26 AM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,408
|
Re: 01 EZGO Won't Go need Help !!
Cart runs fine in the air... can't go on the ground.
Every electronic part is working. Most likely the batteries are bad. Attach a voltmeter to the battery pack. Note the reading, now watch the meter when you try to go. What was the 'at rest' & lowest readings? |
|
|
|
|
09-09-2016, 10:24 AM
|
#3 | |
|
Master of All Things
Join Date: May 2013
Location: West Columbia, Texas
Posts: 17,980
|
Re: 01 EZGO Won't Go need Help !!
Quote:
|
|
|
|
|
|
09-09-2016, 11:22 AM
|
#4 | |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,408
|
Re: 01 EZGO Won't Go need Help !!
Quote:
 To identify a strip hub observe the axle nut spinning without the tire rotating. |
|
|
|
|
|
09-10-2016, 06:44 PM
|
#5 |
|
Not Yet Wild
Join Date: Mar 2011
Location: Sex Juice Ohio
Posts: 41
|
Re: 01 EZGO Won't Go need Help !!
Not a stripped hub,, now am i checking the voltage to see if it drops at the batteries or at the controller ?
|
|
|
|
|
09-10-2016, 06:56 PM
|
#6 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,408
|
Re: 01 EZGO Won't Go need Help !!
Check the batteries at the batteries. Checking the batteries at the controller would be checking the batteries, the solenoid, and cables in between.
|
|
|
|
|
09-20-2016, 03:46 PM
|
#7 |
|
Not Yet Wild
Join Date: Mar 2011
Location: Sex Juice Ohio
Posts: 41
|
Re: 01 EZGO Won't Go need Help !!
each battery checks at 6.37 Volts and the Set actually checked at 38.22 volts is there a way to test that Speed or throttle sensor down in the floor ?? The small micro switch is to be working OK but not sure on the sensor for no mater how far the rod or pedal is pushed the cart doesn't move any faster or stronger,( I can hold it back by placing my foot against the rear tire an pushing the throttle to the floor )
|
|
|
|
|
09-25-2016, 03:28 AM
|
#8 |
|
Not Yet Wild
Join Date: Mar 2011
Location: Sex Juice Ohio
Posts: 41
|
Re: 01 EZGO Won't Go need Help !!
I've ordered a new TPS switch to try it for no mater what i do the voltage does not drop when the pedal is pressed down.
|
|
|
|
|
09-25-2016, 12:01 PM
|
#9 |
|
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: 01 EZGO Won't Go need Help !!
What are the battery voltages under a load? That's critical. I doubt its the ITS switch
|
|
|
|
|
09-27-2016, 01:15 AM
|
#10 |
|
Not Yet Wild
Join Date: Mar 2011
Location: Sex Juice Ohio
Posts: 41
|
Re: 01 EZGO Won't Go need Help !!
I have No real way of Load testing them !!
|
|
|
|
|
|
||||||
|
|
Linear Mode
