|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
04-02-2017, 03:40 PM
|
#1 |
|
Getting Wild
Join Date: Apr 2010
Location: Aiken South Carolina
Posts: 105
|
Rpm settings locked
have been playing with xct software today after talking to johnnie and scotty.
I see no enable speed limit box. And scotty said to try deselecting monitor rpm on page one and I don't see that either. Im also seeing im selected to 4 pole versus 8 poles. wondering if I have the latest software. |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-02-2017, 06:23 PM
|
#2 |
|
Happy Carting
 Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: Rpm settings locked
You should have the latest updates. What field map is listed?
Switch to 8 pole and look right near there for an option to not monitor or limit rpm. PS When you start a new thread for every post we loose any chance of giving advice based upon the full history of the problem. |
|
|
|
|
04-03-2017, 05:32 PM
|
#3 | |
|
Getting Wild
Join Date: Apr 2010
Location: Aiken South Carolina
Posts: 105
|
Re: Rpm settings locked
Quote:
It's set on 4 pole and I can not change that either. This is all under miscellaneous and I'm sorry about the new thred but I had several problems and the cart would not run until we hit reset on controller . I do want it setup right since I have so much money in the controller and motor . Thanks |
|
|
|
|
|
04-03-2017, 05:35 PM
|
#4 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: Rpm settings locked
Once you hit reset default all my settings are wiped clean.
The map does not show ITS, it will show PDS-DCS-V1 or MOT-B2 V3 or something similar Is it running now? |
|
|
|
|
04-03-2017, 06:29 PM
|
#5 |
|
Getting Wild
Join Date: Apr 2010
Location: Aiken South Carolina
Posts: 105
|
Re: Rpm settings locked
It is running now and seems to be running ok . Had to hit reset because motor would not run and was getting constant blinking red with pedal depressed. Once reset the cart would run . PDS-DCS or something similar is whats at the bottom. I just don't know if all my settings are good under the controller tab and why I can change RPM s or change from 4 poles to 8 poles. Its just aggravating and im sorry to bother you so much
|
|
|
|
|
04-03-2017, 06:58 PM
|
#6 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: Rpm settings locked
You have an aftermarket motor so you MUST run the correct field map for that motor. Failure to run the proper field map voids the warranty.
See your email asap. The correct field map is attached to the email. I would like to go through the resetting of the controller with you. |
|
|
|
|
04-03-2017, 07:28 PM
|
#7 |
|
Getting Wild
Join Date: Apr 2010
Location: Aiken South Carolina
Posts: 105
|
Re: Rpm settings locked
scotty im hooking computer to controller now. if you will give me 10 minutes then call me ill be ready. 803 292-6129 Rick
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Locked??? | Gas Harley Davidson | |||
| Locked up rear end | Electric Club Car | |||
| Engine Locked up, etc | Gas Club Car | |||
| Rear end locked up | Electric EZGO | |||
| Rear end locked up? | Gas EZGO | |||
Linear Mode
