Brake Lights on a Club Car Precedent

[Gupone]

Hello folks.

I have done some searching and was not able to find a definite answer for what I would like to do. I have a 2008.5 Precedent with a Madjax bucket harness. I currently have the LED light bar and tail lights on the car but no brake lights. I have looked on MadJax's website and all i see is the ULK package in which I dont want right now. I only want to add the brake lights but dont even want the MJ type were you drill into the stop pedal. I would prefer the linkage and timer that I see being installed under the floor mat.

Does anyone know if this is possible and if so, will it work with the MJ bucket harness and how.

Thank you in advance.

[Gupone]

Anyone have any ideas? Help would be much appreciated.

[Aflyer]

I don't know anything about the Madjax bucket harness.

But if it has three wires going to each tail light you should be good to go.

Check out this video, but this is a pre 2008 Precedent with a factory bucket harness.

https://www.youtube.com/watch?v=Ln-_h89dyw4

Aflyer

[Gupone]

Thanks for the response... the video link you sent did not show the install of the brake light setup. I have the MadJax bucket harness schematic so I can check if it has the three wires under the floor board...

If anyone else has some info, please post.