Ez-Go TXT and Double Take Titan Body fit issues.

[mgray70]

Originally Posted by hawmarine

So after talking to Cutom Inc (makers of DoubleTake, they never sent the accessory bag with the rivets and body clips in it. As well I called the people I got the diamond plate kit from. Itbdidnt come with directions. Evidently after you install the two bolts the bolt the diamond plate cover where the sill plate attached, you have to take a jack and jack up the back of the diamond plate trim until the gap closes between the body and the trim. Here's what it looks like before you jack it up and screw it in place.

Yes, there is suppose to be bracket that rivets to that hole in the side and it rivets to the frame, that holds the body solid. Then you should be able to put the original plastic pieces back on and then the trim should cover it. I done several of those bodies and that's how I usually do it.

Sent from my SM-G930R4 using Tapatalk

[ARKSoft84]

Originally Posted by mgray70

Yes, there is suppose to be bracket that rivets to that hole in the side and it rivets to the frame, that holds the body solid. Then you should be able to put the original plastic pieces back on and then the trim should cover it. I done several of those bodies and that's how I usually do it.

Sent from my SM-G930R4 using Tapatalk

I thought about riveting mine to the side of the body. The instructions tell you to use the supplied bolt and nut to bolt it onto the body. That is what I have done for now. If that bolt gets loose or something like that then I'm going to rivet it.

[mgray70]

Originally Posted by ARKSoft84

I thought about riveting mine to the side of the body. The instructions tell you to use the supplied bolt and nut to bolt it onto the body. That is what I have done for now. If that bolt gets loose or something like that then I'm going to rivet it.

The last one I did I used rivet and it worked good and looks a little better.

Sent from my SM-G930R4 using Tapatalk

[cv2065]

Originally Posted by hawmarine

I actually bought a entire Powder Coated Diamond plate kit that includes the floor. It goes over the rubber mat and then the side trim goes on and it get bolted in place. Ready for this build to be done.

I have the same body and just riveted the rear on. Body is solid after the brackets are put on.

Question regarding the diamond plate rocker panels. Did you have to notch them because of the metal brackets on the sides to get them to fit flush?