???? year ezgo txt

[jim,s]

Im working on a ezgo txt 36 volt series cart. The forward/reverse switch was burnt up. I put new ends on all the large cables and replaced the F&R switch. I looked the cart over pretty good and did not find a cause for this failure.
Is the plug from the harness near the controller with 4 wires white black red and green the place to test the throttle sensor (can't think of what its called) without lifting the floor mat. I believe its the cable that comes from the box in the floor.

The solenoid checks out good, there is power going to the controller. Could it be the motor, I even have pack voltage going to the new F&R switch. but still a cart that won't move.


About 2 years ago I had the same problem with a ezgo medalist and it turned out to be the controller.