Wiring Diagram

[libertybellcdr]

Hey Guru's!

I am working on installing my electrical system. I have all the components.

I have a Logisystems Controller. I have 2 different wiring diagrams. One says "for a Logisystem or Alltrax", the other says "for Alltrax".

On the LGS or AXE diagram, the wires that run from the motor (A2, S1, S2) show them going to the F/R Switch. The problem is that the F/R switch doesn't have them numbered. Just going there.

The AXE only diagram shows the F/R switch, but no wires are listed to run to it. Just general direction.

Please advise...

[libertybellcdr]

I have made some progress on this:

I found on the AXE diagram where the F/R switch numbers are.

I have almost all accounted for, except the LGS diagram shows B+ going directly to A1 on motor. The AXE diagram shows B+ going to F/R #3. Then, A1 going to F/R #4

Anyone have any idea which is correct for my application?

[scottyb]

This diagram is for my cable installs it will work for the LGS & Alltrax Series Controllers. They are wired the same . The F&R is viewed from the rear of the cart looking forward.