Everything getting 38V but not moving

when "jumping" , what are your connections ?

[tlfinn]

hey you and me both...i have been chasing this thing in circles trying to fix it...again like i said I really appreciate any help you can give me...

ok ... lets try some jumping ... again jack up cart and put on jack stands
with a jumper (i would use 1 car battery jumper cable)
following the color diagram (not factory colors) below jump each cable and test with go pedal ... forward then reverse... remember just a quick test .. stop when motor turns and post what happened
i would do it in this order
green
yellow
blue
orange
red (not charger lead)
purple
gray
lt blue

[tlfinn]

for jumping the motor i used a short jumper wire from A2 to S2...then Neg- to S1 and Pos+ to A1

I will the wiring test you sent me this afternoon when I get out off work

work ?
that's a four letter word !!!
i'll check in after i get back from the beach

[tlfinn]

Beach?!?! oh man so people got it made

ok back from the beach

[tlfinn]

looks like you had nice weather:limo:

i did the wiring test ...nothing

[Epb]

Have you taken apart the accelerator switch? Also there is a diode & capacitor in series internal of the controller that connects the a2 b- terminals maybe this is the problem?
Ctd- (you have the good life)....what do you think?

[tlfinn]

is there any way to bypass or test it to see if thats the case??

with the key off ,in neutral...should the A1 A2 post be reading like 32-33V ?????