Club car wont move need help to troubleshoot

[Nevets69nova]

Just picked up this 48v club car supposed to only need batteries but of course it didint dont now year hard to understand code 2000 i think serial A0052-965851 batterys wouldnt take charged so replaced with new batterys still didnt do anything jumped selinoid then selinoides started working fine relaying power to motor controller here clicking when push down peddle but no power comes out comtroller to motor still 50v at batterys and to controller fx503g014-607 motor is a 5bc58jbs6381 car f&r seems to work here buzzer and relays click when change from f to r with it in f have power 49v ata1 and a2 and 4v at f1, 0v at f2 when bettal not pressed when pressed down readings are a1 47v,a2 47v,f1 0v,f2 0v if anyone can point me were to go or test next would be great thanks

[NoleFan4Ever]

Since that is a '00 it appears you have a Regen 2 cart. F1/F2 tells you that is a Sepex motor. So you should have a rocker style Fwd/Rev switch, Run/Tow switch under the seat and a sepex motor which will have a speed switch and harness on the non-driven end of the motor.

Take your DVM and check the voltage between the A2 terminal and the A1 terminal on the motor. You should see ~5vdc with pedal up and proportionally going to 48vdc (or pack voltage) as you depress to full throttle.

[Nevets69nova]

Thanks for reply will check voltages when get home from work motor is a GE motor & GE sx motor controller cart might be modified with different motor was used by police department

[Nevets69nova]

Checked voltage nothin at all when in forward pedal up 0v and 0v all the way to the floor

[Nevets69nova]

Did further tests a1 to at2 0v then took my vglide throttle switch out and took apart and ohm'd out between purple and white/black 0 ohm's tested all others with lever at all positions nothin. have continuity between yellow and the terminals if lever is touching that pad. Even took resisters out and got nothin no ohm reading does that mean i have to get a new vglide for throttle

[NoleFan4Ever]

No output from the controller. Now lets see in you have any input to the controller from the throttle.

You do have the MSP (v-glide) which is the pie shaped device under the seat buy the batteries?

If so, with the cart jacked up, in forward, and key on, Red probe into the yellow wire coming out the v-glide and and black probe on pack Negative. Check the voltage from pedal up to pedal down and it should go from 0vdc to 5vdc gradually changing.

[NoleFan4Ever]

Looks like we were typing at the same time. Try above and see what you get.

[Nevets69nova]

Did test still had nothing pound V Glide video on YouTube on troubleshooting and found that the switch was wired for normally closed needed to be normally open rewired to normally open tested and started working thanks for the help

[NoleFan4Ever]

Glad you are going....