1999 club car ds won't move please read

[NoleFan4Ever]

Sergio, on this cart shouldn't Pin #7 be around ~.5 volts or less pedal up and then gradually increasing voltage to 3.5 volts when at pedal fully down? (That is how I checked these is the past.... but on resistance/Ohms it started high and went low)

[Sergio]

The Regen2 23 pin Silver Controller 2 solenoids should be 3.5v to 0v.

I don't recall now if the 2nd version of Regen2 that only had one Solenoid worked the way You mentioned, I will try to check it in a while.

[NoleFan4Ever]

No biggie. I just saw the transposition from mine and thought it may be a typo, but I may have been testing differently. On my notes for Regen2 that was how I had it listed and they were 23 pins of course.

[moderyan]

Originally Posted by Sergio

I just noticed when I added all of the requirements for the test and formatted for easier reading that I left the throttle signal pin # from the previous post.

I edited the original post, but the throttle test with key ON and FNR in forward should read:



The signal needs to be 3.5v (no less than 3.0v) when the pedal switch closes and go smooth all the way down to 0v as You press the pedal.

I apear to be having similar issue. everything seems to check out up until this point. on that yellow and black wire with pedal activation I do not have voltage. well I have like .1 or .2 volts. does this mean I have an issue with the pedal pot?