|
Electric golf carts Harley Davidson, Melex, Pargo, Taylor-Dunn and other Misc. Carts. |
|
Thread Tools | Display Modes |
11-07-2014, 12:44 PM | #1 |
Not Yet Wild
Join Date: Nov 2014
Posts: 1
|
Testing POT on Zone cart with multimeter
I'm troubleshooting a golf cart that won't go and I'm down to either the accelerator pedal POT or the Curtis 1268 controller. Using the wiring diagram from Curtis, I'm testing for resistance when i move the pedal on pin 13, 14, and 15. (Attached diagram)
When I check with the mulimeter set to Ohms, ignition off, and press the pedal, I show no change at all. Then I noticed when I looked in the pin connector, only 14 appears to be in use. 13 and 15 appear to be empty. Any assistance or opinion is appreciated. Also alternative suggestions on testing the POT before I change out the controller. Thanks! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-07-2014, 04:20 PM | #2 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,410
|
Re: Testing POT on Zone cart with multimeter
Maybe they count from the other side?
|
|
|
Similar Threads | ||||
Thread | Forum | |||
New cart - not zone, etc | Star and Fairplay | |||
Determining multimeter readings CC 48 volt series cart | Electric Club Car | |||
Testing Pack, fried my Multimeter. | Electric Club Car | |||
Multimeter- OK I make eyeglasse- what setting do I use for my cart | Electric EZGO | |||
Testing with multimeter | Electric EZGO |