|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
10-22-2010, 07:46 PM
|
#1 |
|
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
where to ground
on my G16 cart where is a good place to ground my frame from the neg of my battery for my switch/harness to start my engine ?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
10-22-2010, 08:04 PM
|
#2 |
|
Gone Wild
 Join Date: Jan 2008
Location: Covington, TN
Posts: 1,942
|
Re: where to ground
Ground back to the battery.
|
|
|
|
|
10-22-2010, 08:09 PM
|
#3 |
|
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: where to ground
no from my battery to my cart frame where is a good spot to put the other end of the cable ?
iv tried to ground it but it does not get ground connection how is that |
|
|
|
|
10-22-2010, 08:43 PM
|
#4 |
|
Not Yet Wild
Join Date: Jun 2010
Location: Finksburg,Maryland
Posts: 20
|
Re: where to ground
do NOT ground to frame you will blow fuses!!
|
|
|
|
|
10-22-2010, 09:07 PM
|
#5 |
|
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: where to ground
what do i ground it to then ? the diagram says to ground it but to what ? the key switch will not work with out a ground right ?
|
|
|
|
|
10-22-2010, 09:11 PM
|
#6 |
|
Gone Wild
Join Date: Aug 2009
Location: Cedar Hill, Missouri
Posts: 290
|
Re: where to ground
i found out the hard way by blowing fuses also. run all grounds to the battery.
|
|
|
|
|
10-22-2010, 09:13 PM
|
#7 |
|
Gone Wild
Join Date: Jan 2008
Location: Covington, TN
Posts: 1,942
|
Re: where to ground
Are you adding 12 volt accessories? Or is the for the blig block?
|
|
|
|
|
10-22-2010, 09:15 PM
|
#8 |
|
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: where to ground
ok... even my 12v solenoid for the key switch just bolt a wire to it and to the neg post on the battery.
edit: im adding lights and may be some other things down the road and yes its for my big block engine |
|
|
|
|
10-22-2010, 09:24 PM
|
#9 |
|
Gone Wild
Join Date: Jan 2008
Location: Covington, TN
Posts: 1,942
|
Re: where to ground
Not sure exactly but there should be about 5 wires(or pins for wires) on the key switch for the BB. One will go to the magneto(SP), a hot , ground and access. Maybe Big Block Man or some one else will chime in on the key switch. I put in a junction box for my lights and accessories which will have a larger ground and hot going to it and then you can hook up several hot/ground accessories there with fuses.
|
|
|
|
|
10-22-2010, 09:29 PM
|
#10 |
|
Gone Wild
Join Date: May 2010
Location: OHIO
Posts: 1,517
|
Re: where to ground
well i had a harness made for it and they marked where every wire went to...well i hooked up every wire and nothing happened, i check the ground and nothing going to it.
i guess tomorrow ill try taking all the ground wires and hooking it up to my neg post of my battery i have one heavy wire going from the starter to the solenoid side post and the other larger side post going to the POS of the battery and i have to top bolts one they marked as ground and the other to charge my battery if i remember correctly if all this sounds right might just be a ground problem |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 48V frame ground on conversion... Ghost Ground! | Extreme DC! | |||
| frame ground | Electric EZGO | |||
| Frame Ground - How could it be? | Electric Club Car | |||
| Ground?? | Electric Club Car | |||
| The Mongrel on the ground | Gas golf carts | |||
Linear Mode
