|
05-25-2016, 08:38 PM
|
#1 |
|
Not Yet Wild
Join Date: May 2016
Location: NE OK
Posts: 39
|
slip collar nut deal
Well I learned a new lesson this evening, of course by breaking something. I was going to adjust the throttle linkage, and from what I understand it should be 3/4 - 1 inch movement at the top of the peddle before the engine kicks in. While loosing up the lock nuts on the rod from thre peddle to the electrical box I broke the little part that slips over the ball joint on the peddle end. I did not know I could just slip it back and pop it off. So while trying to loosen the lock nut I split the slide collar.
Where do I find one of those?  |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
05-25-2016, 10:11 PM
|
#2 |
|
What the ....?
 Join Date: Jan 2007
Location: N.E. Wisconsin
Posts: 14,932
|
Re: slip collar nut deal
Well, there's a new one!
most people break the ball, and not the joint!  That part is called a ball joint... CC part #1011734 It's a pretty common replacement part, here's just one for example... https://www.golfcartking.com/club-ca...joint-end-cap/  |
|
|
|
|
05-25-2016, 11:11 PM
|
#3 |
|
Not Yet Wild
Join Date: May 2016
Location: NE OK
Posts: 39
|
Re: slip collar nut deal
If it's upside down and backwards - I'm your man, I can do what most don't!
 Good deal, I'm on this. Thanks man!!! |
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| g1 clutch collar | Gas Yamaha | |||
| primary clutch collar | Gas Yamaha | |||
| Slip-Joint or Slip-Shaft for lifted carts? | Design Center | |||
| I Need Change Roller Collar, Help??? | Gas Yamaha | |||
Linear Mode
