|
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
01-07-2019, 05:05 PM | #1 |
Gone Wild
Join Date: Oct 2018
Posts: 169
|
G19e motor ,brush inspect,or replace
Have the motor on bench,want to get end cap off,have removed the 4 long screwsat end cap,
Does the pig tail need to come off? There is two screw driver type head screws on end cap do they come out before end cap comes off? Can I tap on splined end of armature with brass hammer to get end cap off? |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
01-08-2019, 10:21 AM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: G19e motor ,brush inspect,or replace
The two screws hold the bearing retainer ring, they need to come out, and you will need longer screws to grab it to put ring back in place on reassembly. Mark the cap so the wires point to the same terminals as they originally did to ease reinstall.
|
01-08-2019, 11:40 AM | #3 |
Gone Wild
Join Date: Oct 2018
Posts: 169
|
Re: G19e motor ,brush inspect,or replace
Brushes looked fine,they were still protruding 1/2" above the brush holder,
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G19e motor | Electric Yamaha | |||
Yamaha g19e roof material replace | Electric Yamaha | |||
Help with brush replacement/brush and brush wiring placement | Electric EZGO | |||
Checklist to inspect cart for purchase ? | Electric EZGO | |||
Picking up an 04' G22 Gas Yammerhammer today! What should I inspect | Gas Yamaha |