FE290 piston installation???

BLES · 05-14-2010, 12:29 PM

Re-assembling an FE290 (1997) that was previously taken apart (so I don't know this is how it came from factory). Which way does the piston go? The FE290 manual I have dated 2000 shows some each way, depending on the version. I am assuming this is to do with crankshaft rotation or something.? I know the rod goes with "made in Japan" toward the crankcase cover side, but not sure about the piston. It was installed with the arrow on top pointing to the flywheel side, but I'd like to verify that it was correct. Any engine rebuilders here? Thanks in advance.
BLES

05-14-2010, 12:29 PM	#1
BLES Not Yet Wild Join Date: Feb 2009 Location: Saskatchewan, Canada Posts: 65	FE290 piston installation??? Re-assembling an FE290 (1997) that was previously taken apart (so I don't know this is how it came from factory). Which way does the piston go? The FE290 manual I have dated 2000 shows some each way, depending on the version. I am assuming this is to do with crankshaft rotation or something.? I know the rod goes with "made in Japan" toward the crankcase cover side, but not sure about the piston. It was installed with the arrow on top pointing to the flywheel side, but I'd like to verify that it was correct. Any engine rebuilders here? Thanks in advance. BLES

Similar Threads
Thread	Forum
piston	Gas Club Car
g1 piston	Gas Yamaha
EZ go piston and rods	Gas EZGO
244 piston size	Gas EZGO
244 blown piston	Gas EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum