cc shorter belt

[randyrw]

ok I have looked/search all day for the shorter belt to go on a 1995 ds cart. Can anyone send me in the right diection or better yet tell me what size I need.
The belt on there now reads 1349 made in USA 4707-283.
Ihave measured its width and it comes out to 15/16 wide.
Can someone help me out.

I have done the shorter belt on my workhorse and am happy with it but just cant find anything on the club car I just got.

[JW67]

What year is your club car? On 96 1/2 and older, you can move the engine forward to tighten it.

[shoelessjoe]

Have seen recommendations on this site for the Gates #6013 belt as a shorter replacement for the stock belt.

Gates is 29/32 wide x 36 3/4 long where as the stock is 1 wide x 37 3/8 long.

[randyrw]

Originally Posted by JW67

What year is your club car? On 96 1/2 and older, you can move the engine forward to tighten it.

it is a 1995. here are the serial #ag9337348747. and I just noticed I am wrong on the year. It is a 1993 not a 1995.

[randyrw]

So since I made a mistake on the year does that change the belt size or are they still the same for that year.

[Doc's BoneCracker]

Originally Posted by randyrw

So since I made a mistake on the year does that change the belt size or are they still the same for that year.

it might I found that the 96 and up will for sure work with the 6013 but 96 and older might not be right. Measure old belt and go online to NAPA and there you can do a search of belts by size. If you post your length and width I can help you find it. If the length is the same or close to the post above the the .01" is no big deal that allows for faster response on take off.

Kurt

[randyrw]

ok , Thanks I will check and measure the belt this weekend.

[shoelessjoe]

Originally Posted by shoelessjoe

Gates is 29/32 wide x 36 3/4 long where as the stock is 1 wide x 37 3/8 long.

These measurements are based on what I found to be a stock replacement for my 96 Club car.