Alltrax XCT 500 PDS help

[TBcart]

Hi all, I was looking into why my horn didn't work, and when I pulled the key switch dash panel out I dropped a screw driver across the ignition switch terminal and the light switch terminal on the key switch. My key switch has 4 connection points on it . Well it sparked and kinda made a small burn mark on the terminal and screwdriver. Now my controller is not working at all. Is there a way to reset it or re boot it? The cart is an ezgo Textron 36v. The alltrax controller still has 36v still going to it, I am just not getting voltage to the key switch. Out of the C1 pins 8 and 9 for the key switch I don't remember which one had power but one is 0 volts and the other is 2.2 volts. The Indicator led on the alltrax unit is not on now and the fan is not on either. The unit is in run not tow. Do you know if there is a way to reboot them. Thanks for your help.

[Volt_Ampere]

Is there a fuse in that circuit? There is on my Yamaha cart. Hook your laptop to the Alltrax and see if it's alive at all. Next time don't tinker with anything without disconnecting the battery!!!

[scottyb]

Check the reed switch inside the charge receptacle and check the pedal micro switch. These 2 small switches burn like fuses in this cart when there is a catastrophic short.